Skip to main content

Set a project's routing mode

Do this when you want Jaah to choose the runner for a project's tasks, or only to suggest one. Each project has its own routing mode, under Routing in its Settings › General. Your organization sets the highest mode any project may use; a mode above it can't be picked.

Who can do this: anyone who may edit the project.

Plan: needs intelligent routing on your plan. Without it, or while your organization's maximum is Off, Routing is hidden, unless the project still has a mode or Blind review on, so you can turn them off. See Limit what intelligent routing can pick.

  1. In the sidebar, select Directory, then the Projects tab.

  2. Select the project's name. Its page opens on General.

  3. Select Advanced to open the fold, and find Routing.

  4. In Mode, pick how far routing goes on this project:

    • Off: no routing; tasks run as picked.
    • Recommend: each task shows the router's pick; you choose.
    • Auto: tasks run on the router's pick.

    A mode above what your organization allows is greyed out, with the reason under the field.

  5. In Latency cap, type the most hours a routed task may take. Leave it empty for no cap.

  6. In Experiment budget, type the share of the last 30 days' spend routing may use to try other runners and benchmarks. The same number caps the Benchmark tab's monthly spend.

  7. To have other agents review a task's pull request without its author's reasoning, check Blind review. It applies only to major and security changes. If it can't run yet, it stays unchecked and a line under it says why, such as no node of the project being able to.

  8. With Blind review on, check Prefer a different vendor so the reviewer comes from another vendor than the author, where one is allowed.

  9. Select Save at the bottom of the page. Save stays disabled until something changed. To undo your edits before saving, select Discard.

On a project Jaah manages for you, Routing is not shown.

To see what routing chose for a task, open the task and select its Routing tab: see Choose what a task runs on.