Let members pin a task to a node
Jaah runs each task on any free node of its project. Sometimes a task needs one node, such as the one with a tool or a device installed. The Node picker setting adds a Node field to the task form so people can choose. It is off by default. While it is off, a node stored on a task is ignored and the task runs on any of the project's nodes.
Who can do this: the Org Owner or Org Admin role turns it on. Then anyone who writes a task can use it.
-
In the sidebar, select Settings. Under Organization, select Tasks.
-
Find Node picker in the Defaults section. Default · off means it is off.

-
Tick Node picker. It saves at once, with no Save. Reset to off now takes the place of Default · off.
-
Start a new task as usual and pick its project, then select Advanced.
-
In Node, pick one of the project's nodes, or leave Any to let Jaah take a free one.
-
Select Go.
A task pinned to a node runs only there, so while that node is busy or offline the task waits in Queued. To turn the picker off again, select Reset to off; tasks already pinned then run on any node.
The capture shows the setting off: the organization it was taken in keeps it off, so the Node field on a new task could not be photographed.
Related
- Choose the agent and account a task runs on: pin the agent, account and model as well.
- Start a task: write and send a task.
- Settings: the Tasks category.